Powering The Unit; Turning The Power On And Off - Tascam Portscapture X8 Manual Del Usuario

Powering the unit

This unit can be powered in two ways: with AA batteries or
by external power using the USB port.
Using AA batteries
1.
Remove the battery compartment cover, and insert 4
AA batteries with their ¥ and ^ marks oriented as
shown.
2.
Reattach the battery compartment cover.
NOTE
i This unit cannot recharge Ni-MH batteries. Use a
commercially available recharger.
i The included alkaline batteries are for confirming opera-
tion of the unit and might not last very long.
10
TASCAM Portacapture X8
Using external power
Connect the USB port on the unit to an external power
supply.
This illustration below is an example of connecting a PS-
P520U AC adapter (sold separately) to the unit.
TASCAM PS-P520U (sold separately)
Type-A to Type-C cable included
with PS-P520U
USB-C plug
CAUTION
We highly recommend using the AC adapter designed
for use with this unit (PS-P520U sold separately). When
using another external power supply, use one with the
following specifications.
o Supplied voltage: 5 V
o Supplied current: 1.5A or more
Using an external power supply with specifications other
than the above could cause malfunction, overheating, fire
or other problems.
If anything abnormal occurs, stop use and contact the
retailer where you purchased the unit or a TASCAM cus-
tomer support service to request repair.
NOTE
i If an external power supply that provides current less
than 1.5 A is connected, the unit will automatically enable
the POWER SAVE MODE, restricting some functions.
i When using the factory default setting, if an external
power supply is connected, power from it will be used
even if batteries are also installed.
Power supply settings can be changed with the GENER-
AL SETTINGS screen > POWER/DISPLAY page > POWER
SOURCE SELECT item.
i See the Reference Manual for details.

Turning the power on and off

AC outlet
Turning the power on
Slide the ¤/HOLD switch toward ¤ until the display is
activated. Then, release the switch.
When the unit starts up, the touchscreen display becomes
active.
The first time the unit is started, the LANGUAGE screen will
open. From the second time, the HOME screen of the app
selected on the LAUNCHER screen when the unit was last
turned off will reopen.
Turning the power off
Slide the ¤/HOLD switch toward ¤ until the display is
deactivated. Then, release the switch.