Mounting The Bike Handle - Stihl FS 160 Manual De Instrucciones

English
► If the machine support is supplied separately –
use the two M5x16 screws to mount the
machine support (4) to the underside of the
engine.
► Unscrew the center screw (6) from the
sleeve (7) and pull the cap (5) off the clutch
housing (8). Then push the cap onto the drive
tube.
► Push the drive tube through the sleeve and
into the clutch housing (8) until the hole (9) in
the drive tube lines up with the tapped
hole (10) in the sleeve.
64
► Fit the center screw, but do not tighten it down
yet.
► Insert the two M5x20 screws provided and
tighten them down firmly.
► Push the cap (5) over the sleeve so that the
opening (12) lines up with the tapped hole (10)
in the sleeve.
► Tighten down the center screw in the
sleeve (7) firmly.
5

Mounting the Bike Handle

5.1 FS 160 – Mounting bike handle
with fixed handle support
The fixed handle support is supplied separately
and must be mounted to the drive tube.
5 Mounting the Bike Handle
0458-323-8721-D