Philips AQ 6345 Manual Del Usuario página 7

00 02-02-2000 11:02
DING
G TAPES FROM ACCIDENTAL ERASURE
a particular cassette, simply break out the left
g on this side is no longer possible. If, however,
ecord over this side or a tape with open tabs,
s with a piece of adhesive tape.
(ACTivation)
is a sound level sensor system which enables you
y when the microphone receives sound at the
The VOLUME wheel acts as the control for the
ensor. If sound stops or falls below the volume
the preset level, recording will pause hence
mpty recording. To activate:
CE ACT to ON.
UME:
kwise – the sound level sensitivity drops and
only sound near the microphone will be
recorded.
se – sound sensitivity is increased. Distant and
background sounds will be picked up.
All manuals and user guides at all-guides.com
Pagina 7
Note: When the recording pauses and is resumed
automatically according to the preset sound level, the
beginning of the track can be lost due to the recording
cut off and starting points.
BACKGROUND NOISE SUPPRESSION (BNS)
When in noisy surroundings, to achieve a clearer and better
defined voice recording, activate the BNS switch. The BNS
system emphasizes the frequency range of the human voice
while reducing both the high and low frequencies that usually
comprise noise. If you like, use BNS with VOICE ACT during
recording.
MAKING YOUR RECORDING
1. Open the cassette door and insert a tape (see fig. 2).
2. Press the door lightly to shut.
3. Adjust BNS and VOICE ACT to ON /OFF to suit your
recording mode (see VOICE ACT and BNS chapters above).
• If you do not wish to use the FLAT MIC built-in
microphone, insert an external microphone with a 3.5 mm
plug into the MIC socket and point to the sound source.
Make sure that you direct the microphone away from the
set to avoid a howling sound. Once the MIC is connected,
the FLAT MIC will not pick up sound.
7