Troubleshooting - Westward 13G264 Instrucciones De Operación Y Manual De Piezas

Westward Operating Instructions and Parts Manual

TROUBLESHOOTING

TROUBLESHOOTING TROUBLESHOOTING TROUBLESHOOTING
FAULT FAULT
FAULT FAULT
A. Does not punch hole
B. Requires excessive lever force.
C. Pump does not build pressure.
HYDRAULIC PUNCH SET, KNOCKOUT W6 PUNCH, 2
STUDS, 1 SPACER, 1 SEALING KIT
ANALYSIS ANALYSIS
ANALYSIS ANALYSIS
1. Improper assembly or use of
punch, die, or accessories
2. Low oil level
1. Improper assembly or use of
punch, die, or accessories.
2. Material being punched is too thick
or too hard.
1. Air in system
2. Oil leakage on the ram
6
SOLUTION SOLUTION
SOLUTION SOLUTION
1. Refer to "Operation" and
Capacity and Draw Stud selection
Guide."
2. Refer to "Adding Hydraulic Oil:
in the "Maintenance" section
1. Refer to "Operation"
2. Refer to "Capacity and Draw
Stud Selection Guide"
1. Prefer to "Adding Hydraulic Oil"
in the Maintenance Section.
2. Contact manufacturer or
distributor and replace it by trained
person
13G264