Maintenance; Maintenance Schedule - Husqvarna R 316TX Manual De Usuario

3. Put the strap through the rail bracket (B) on the
opposite side.
4. Use the rail brackets to attach the load with straps.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
1. PREPARE THE PRODUCT
Do a check of the battery.
Do a check of the blades.
Do a check of and clean hydraulic hoses and couplings. Replace if necessary.
Do a check of the belts and pulleys.
Do a check of the steering chain of the inner side of the frame tunnel.
Do an inspection, lubricate and adjust all wires.
Make sure that the tire pressure is correct. Refer to
Make sure that all screws and nuts are tightened with the correct torque.
Lubricate the operators seat.
Lubricate all chains.
Lubricate the wheels and blade bearings on the cutting deck.
Lubricate the pedals on the inner side of the frame tunnel.
Lubricate the belt tensioner.
Remove the drive wheels and grease the axels.
2. ENGINE
Do a check of the fuel hose. Replace if it is necessary.
Replace the fuel filter. Refer to
Replace the air filter. Refer to
Do an inspection of the cooling fins on the hydrostatic transmission.
Clean the engine and the hydrostatic transmission.
Do a check of the muffler and the heat deflector.
844 - 009 - 25.11.2021

Maintenance

Before you do any
Tire pressure on page 25 .
To replace the fuel filter on page 23 .
To clean and change the air filter on page 23 .
CAUTION:
rails. Refer to
35 .

Maintenance schedule

First
servicing
First
servicing
Do not overload the
Technical data on page
Maintenance interval
in hours
50 100
O
O
O
O O
O
O
O O
O
O
O
O O
O
O
O
Maintenance interval
in hours
50 100
O
O
Clean O
O
O
O O
200
200
19