Know Your Product; Safety Devices - Ryobi RCS1935 Instrucciones Originales

upon exposure to cold. Hereditary factors, exposure to
are all thought to contribute to the development of these
Keep your body warm in cold weather. When operating
warm. It is reported that cold weather is a major factor
contributing to Raynaud's Syndrome.
After each period of operation, exercise to increase
blood circulation.
exposure per day.
retailers are designed specifically for chainsaw use
which give protection, good grip and also reduce the
effect of handle vibration. These gloves should comply
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor about
these symptoms.
WARNING
Injuries may be caused, or aggravated, by prolonged
use of a tool. When using any tool for prolonged periods,

KNOW YOUR PRODUCT

See page 233.
1. Chain
Guide bar
Front handle
5. Trigger release
Rear handle
Chain lubricant cap
Cord retainer
11. Wood chips deflector
Chain tensioner adjustment ring
15.
Guide bar cover
Chain catcher

SAFETY DEVICES

Low kick-back saw chain
cutters from digging in too deeply. Only use replacement
guide bar and chain combinations recommended by the
manufacturer.
As saw chains are sharpened, they lose some of the low
6 | English
All manuals and user guides at all-guides.com
safety, replace saw chains when cutting performance
decreases.
Spiked bumper
steady while cutting. When cutting, push the machine
by moving the rear handle up or down in the direction of the
cutting line it can help ease the physical strain of cutting
Guide bars
Generally, guide bars with small radius tips have somewhat
and matching chain which is just long enough for the job.
not correct.
Chain brake
towards the bar, the chain should stop immediately. A
tested before each use for correct operation in both the run
ASSEMBLY
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.
ASSEMBLING SAW CHAIN AND GUIDE BAR
See page 234 - 235. See page 244 - 245.
1. Disconnect the mains plug. Wear protective gloves.
5.
WARNING
The saw chain should face in the direction of chain
bar.
Hold the chain in position on the bar and place the loop
bolt goes through the hole in the attached chain tension
assembly. You may need to rotate this assembly so the
bolt and hole align. You may rotate this assembly again
it in place.
adjustment ring until the saw chain is properly tensioned.