Pre-Start Inspection Procedures - Mi-T-M GP Serie Manual Del Usuario

INSTALLATION & PREPARATION

PRE-START INSPECTION PROCEDURES:

Before starting the unit, perform the following procedures:
. Check the oil level in the pump and engine.
2. Inspect the water inlet strainer. Clean or replace if necessary. See "Water
Supply", #2, pg. 4.
3. Check all hose connections to ensure they are securely tightened. See
"Water Supply", #3, pg. 4.
4. Inspect for system fuel leaks. If a fuel leak is found, DO NOT START UNIT!
See "Risk of Explosion or Fire", pg. 4. Be sure that all damaged parts are
replaced and that the mechanical problems are corrected prior to operation
of the unit. If you require service, contact Customer Service.
5. Inspect high pressure hoses for kinking, cuts and leaks. If a cut or leak
is found, DO NOT USE HOSE! Replace hose before starting unit. See
"Risk of Injection" pg. 5. Be sure that all damaged parts are replaced and
that the mechanical problems are corrected prior to operation of the unit.
If you require service, contact Customer Service.
THE FOLLOWING PAGES CONTAIN OPERATING
AND MAINTENANCE INSTRUCTIONS
DO NOT ATTEMPT TO OPERATE THIS
PRESSURE WASHER UNTIL YOU HAVE READ AND
UNDERSTOOD ALL SAFETY PRECAUTIONS AND
INSTRUCTIONS LISTED IN THIS MANUAL.
INCORRECT OPERATION OF THIS UNIT CAN CAUSE
SERIOUS INJURY!!
DO NOT ALTER OR MODIFY THIS EQUIPMENT IN ANY
MANNER!
GP-SERIES Operator's Manual
END OF PREPARATION INSTRUCTIONS
WARNING
5