Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. The air must not be discharge into a flue that is used for exhausting fumes from appliances burning
gas or other fuels" "Regulations concerning the discharge of air have to be fulfilled.
5. Install wall cap. Connect round metal ductwork to cap and work back towards hood location. Use
duct tape to seal the joints between ductwork sections.
Install electrical
Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and
standards. This range hood must be properly grounded. Turn off electrical power at service entrance
before wiring.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Install the hood
Note 1 : On stainless steel hoods, carefully remove the plastic protective film from all exterior surfaces of
the hood and chimney prior to final installation.
Note 2: At least two people will be required to mount the hood.
Install the hood
Minimum hood distance above the cooker must not be less than
650mm.
A maximum of 750mm above the cooker is highly recommended for best
capture of cooking impurities.
Distance over 750mm above the cooker are at the installer's and user's
discretion - providing that ceiling height and flue length permit.
1.
he hanger units should fix on the ceiling by ST5*45 (4 sets, including screws and plastic dowel),
T
there should be a plug in the range of hanger.
2. Install adjusting holder and fixing holder by 16pcs screws M4*10, you can adjust length in this step,
then fix them in four corner of hood body by 16pcs screws M4*10 like below,
All manuals and user guides at all-guides.com
-26-
Tabla de contenido
