Safety Reset Switch - Waring Commercial VCM1000SK Manual De Instrucciones

• Bowl is overloaded – remove product being processed and reload using
smaller quantities.
If unit does not operate after you have followed the above, and have tried
the Safety Reset Switch
• Check outlet to be sure there is current.
• Check to be sure circuit breaker is ON.
• Check to be sure the fuse is not blown if there are fuses on this circuit.
• Contact your local distributor.
If unit starts to spark or smoke
• Turn unit off, unplug it, and call your local distributor.
If food processor makes grinding noise
• Turn unit off, unplug, disassemble, and check bowl and blade to see if they
have been rubbing together.
• If bowl and blade are rubbing, call your local distributor.
Unit stops running while dicing
• Turn unit off.
• Remove cover. Firmly hold slinger with one hand and rotate slicing disc
counterclockwise and pull up and out of chute.
• Clean grid and slicing blade with tool provided.
How to sharpen "S" Blade
• Hold "S" Blade by the handle on the top of the hub and turn blade
upside down.
• Place the upside-down blade flat on the edge of your worktop so that one
end of the blade is positioned sitting on the worktop and the other end is
extended out away from countertop.
• Run a carborundum stone gently, in a horizontal motion, two or three times
along the flat underside edge of the blade extending out from countertop.
• Next, rotate blade so the other edge is facing out and gently run the
carborundum stone along the flat underside edge of that blade as before.
The SAFETY RESET SWITCH is provided for your convenience and to extend
the useful life of your Waring food processor. It is located on the back of your
machine, on the safety interlock tower, protected by a round finger hole.
The switch button is red.
If the machine should become jammed or somehow overloaded, the safety-
reset switch has a mechanism that will shut down the motor to prevent
overheating and to prevent damage to the motor.
How it works
If the machine becomes overloaded, the shaft and blade will stop turning, but
All manuals and user guides at all-guides.com

SAFETY RESET SWITCH

13