Metrohm 798 MPT Titrino Instrucciones De Uso página 126

3.2. Remote control commands
122
.V: Volume
.Meas: Measured value associated to the cycle number.
The unit "assembly" must be preset (see 3.2.2.122).
3.2.2.124. Setup.SendMeas.Titrator.CyclNo
Setup.SendMeas.Titrator.V
Setup.SendMeas.Titrator.Meas
Setup.SendMeas.Titrator.dVdt
Setup.SendMeas.Titrator.dMeasdt
Setup.SendMeas.Titrator.dMeasdV
Setup.SendMeas.Titrator.ERC
Setup.SendMeas.Titrator.T
Selection of the values from the titrator which are sent in the set time interval
(see 3.2.2.121, formats see 3.2.2.104):
.CyclNo: Cycle number. Together with the cycle time (3.2.2.108), a time
frame can be set up. The other data belong to the corresponding
cycle number. The cycle number is set to 0 at the start of a
method and it is incremented until the end of the method.
.V: Volume.
.Meas: Measuring value
.dVdt: associated volume drift.
.dMeasdt: associated measured value drift.
.dMeasdV: associated 1st derivative of the titration curve.
.ERC: ERC in DET.
.T: Temperature.
The unit "titrator" must be preset (see 3.2.2.122).
3.2.2.125. Setup.AutoInfo.Status
Setup.AutoInfo.P
Setup.AutoInfo.T.R
Setup.AutoInfo.T.G
Setup.AutoInfo.T.GC
Setup.AutoInfo.T.S
Setup.AutoInfo.T.B
Setup.AutoInfo.T.F
Setup.AutoInfo.T.E
Setup.AutoInfo.T.H
Setup.AutoInfo.T.C
Setup.AutoInfo.T.O
Setup.AutoInfo.T.N
Setup.AutoInfo.T.Re
Setup.AutoInfo.T.Si
Setup.AutoInfo.T.M
Setup.AutoInfo.T.EP
Setup.AutoInfo.T.RC
Setup.AutoInfo.C.B1
Setup.AutoInfo.C.R1
Setup.AutoInfo.C.B2
Setup.AutoInfo.C.R2
Setup.AutoInfo.I
Setup.AutoInfo.O
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
798 MPT Titrino