General Description; Technical Data; Assembling The Bar And Chain - GGP ITALY 132508000 Manual Del Usuario

GB
PRUNER FITTED TO BRUSH CUTTER

General description

IDENTIFICATION OF COMPONENTS
1. Bar
2. Chain
3. Oil tank cap
4. Oil tank
5. Fixing nuts
6. Chain guard
7. Chain tightener
8. Fixing flange
9. Fixing screws
10. Adjusting ring nut
NOTE: For maintenance and further information see Safety Measures and Instructions.

Technical Data

Dry weight without bar and chain
Chain pitch
Driving link thickness
Bar length
Oil tank capacity

Assembling the bar and chain

ALWAYS WORK WEARING PROTECTIVE GLOVES
1
B
1) Remove the nuts B and then the chain guard
2) Loosen the screw D to the end of its travel
3) Position the chain in the direction P
4) Position the chain on the pinion, place the pin G in the bottom hole F, fit the
chain guard.
5) Tighten the nuts B by hand; clamp the screw D; tighten the chain until when it is
lifted in the centre it does NOT completely uncover the driving links; when the
chain is pushed along it must run freely. Clamp the nuts B.
22
All manuals and user guides at all-guides.com
0.75 kg
3/8" mini
1.1 mm
250 mm
175 cm
2
G
D
INFORMATIVE NOTE
Pursuant to the company's policy for continual qua-
lity improvement, the manufacturer reserves the
right to make technical modifications to the product
3
without obligations towards any party.
3 4
G
5
B
D