Cord Minders (2 Parts) - Porter Cable PCSRW4800 Manual De Instrucciones

PART 1: CORD MINDERS ASSEMBLY INSTRUCTIONS (FIG. DD-FF)
1. Determine the mounting location for the cord minders. Place a cord minder bracket (32) onto the
upright of the rack and slide it down to secure it in place. Sometimes the cord minder brackets
(32) will need to be tapped down with the palm of the hand or gently with a rubber mallet to seat
properly. (Fig. DD)
2. Install the locking pins (10). (Fig. EE)
3. Place the second cord minder into position so that the distance between the two cord minders
is at the desired length. (Fig. FF)
Fig. DD
32
PART 2: HOW TO USE CORD MINDERS (FIG. GG-HH)
NOTICE
The brackets have four possible positions with 90 degree intervals of rotation.
1. To rotate the bracket (32) pull as close to the base of the bracket (32) as possible. Then rotate to
the desired position and release. Do not pull from the top of the bracket (32). (Fig. GG)
2. When wrapping extension cords or other cables around the cord minder (32), it is recommended
to have the brackets (32) in opposite orientation with the top cord minder (32) in the up position
and the bottom cord minder (32) in the down position (Fig. HH). This prevents the cord from
unintentionally slipping off of the cord minder (32). Do not overload.
3. When removing cords or cables do not attempt to slide the cord off before rotating the brackets
(32). This may cause damage to the cord, the bracket (32), or cause the rack to tip.
Fig. GG
PULL

CORD MINDERS (2 PARTS)

Fig. EE
Fig. HH
TURN
10
14
Fig. FF