Plan Vent System - Whirlpool WETLV27HW Instrucciones De Instalación

Plan Vent System

Recommended exhaust installations
Typical installations vent the washer/dryer from the rear. Other
installations are possible.
A
B
C
A. Dryer
B. Rigid metal or flexible metal vent
C. Clamps
D. Wall
Optional exhaust installations:
24" (61 cm) washer/dryer models can be converted to exhaust
out the right or left side. To convert the washer/dryer, use
Side Exhaust Kit Part Number 279823. If your washer/dryer
was previously exhausted from the right or left side, it can be
converted to rear exhaust by using standard offset connections.
To cover the hole in the side, the following plug can be added:
692790 (white)
Follow the instructions in the kit to install. The kit is available
from the dealer from whom you purchased your washer/dryer.
A
A. Standard rear offset exhaust installation
B. Rear exhaust for offset close-clearance connection
C. Left- or right-side exhaust installation (24" (69 cm)
models only)
26
D
E
F
G
H
E. Elbow
F. Clamps
G. Elbow
H. Exhaust hood
C
B
Alternate installations for close clearances
Venting systems come in many varieties. Select the type best
for your installation. Three close-clearance installations are
shown. Refer to the manufacturer's instructions.
A
A. Loop system with standard elbows
B. Loop system with one offset and one standard elbow
C. Vent system with one periscope (2" (51 mm) clearance)
Venting Kits
For more information, call 1-866-698-2538, or visit us
at www.whirlpool.com. In Canada, call 1-800-688-2002
or visit us at www.whirlpool.ca.
Special provisions for mobile home installations:
The exhaust vent must be securely fastened to a noncombustible
portion of the mobile home structure and must not terminate
beneath the mobile home. Terminate the exhaust vent outside.
Determine vent path:
Select route that will provide straightest and most direct
Ƀ
path outdoors.
Plan installation to use fewest number of elbows and turns.
Ƀ
When using elbows or making turns, allow as much room
Ƀ
as possible.
Bend vent gradually to avoid kinking.
Ƀ
Use as few 90° turns as possible.
Ƀ
B C