camry Premium CR 7853 Manual De Uso página 6

7. Evaporator inlet
9. Down drain hole
11. Connector of air exhaust duct
CONTROL PANEL (picture C)
A. Power button ON/OFF
C. Mode button
E. Timer / Temperature down button
G. Fan high speed indicator
J. Automatic mode indicator
L. Dehumidify / DRY mode indicator
N. Timer button
R. Heat mode indicator
T. Wi-Fi connection indicator
REMOTE CONTROLLER – picture D
The remote controller transmits signals to the system.
Button "A" - if you press this button, the appliance will be started when it is energized or will be stopped when it is in operation.
Button "B" - press it in sequence to select desired fan speed: low or middle or high.
Button "C" - press it to select operation mode: "J", "K", "L", "M" or "R".
Button "D" / "E" - press to adjust the room temperature and the timer.
Button "I" - press to set or cancel sleep mode.
Button "N" - press to set the time of automatic off and automatic on.
Button "O" - press to set or cancel louvers swing mode.
OPERATION OF THE CONTROL PANEL
MODES: AUTOMATIC / COOL / DRY / FAN / HEAT
1. Turn on the device.
a) Connect the device and then the device beeps once.
b) Press the "A" button, then the device will turn on.
c) LED diode displays room temperature and starts working in automatic mode.
2.Choose the operating mode
Press the "C" button to select the desired mode of operation by sequence:
Automatic mode "J" -> Cooling mode "K" -> Drying mode "L" -> Fan mode "M" -> Heat mode "R"
3. Adjust temperature
The temperature can be set within a range 15°-31°C. Press "D" or "E" button to increase or decrease the temperature by 1°C by
pressing once. The device LED panel shows the target temperature for 5 seconds and then displays the room temperature.
4. Adjust fan speed
Press the button "B" to select a desired fan speed shows by sequence:
Low speed "F" -> Middle speed "S" -> High speed "G"
5. Power
When you press the "A" button again, the device will sound "di" and stop working.
6. Press the button "I" to enter the sleep mode of device.
7. Press the button "N" to set a timed shutdown.
8. Press the button "O" to set air swing oscillation up-down..
EACH MODE WORKING PRINCIPLE:
AUTO "J" mode:
Once the "J", operation is selected, the indoor temperature sensor operates automatically and it selects one of below operation
modes:
- When the room temperature ≥24 ℃ the unit will automatically select cool mode "K" mode.
or
- When the room temperature = 23 ℃, the unit will automatically select fan mode "M.".
or
- When the room temperature ≤ 22 ℃, the unit will automatically select heat mode "R".
Dehumidify "L" mode:
1. The upper centrifugal fan will run at low speed, and the speed can't be adjusted.
2. The compressor will stop after running 8 minutes, then run again after 6 minutes.
3. The device adopts constant temperature dehumidifying mode, and the adjustment of temperature is no effective.
8. Upper drain hole
10. Air exhaust duct
12. Window exhaust adapter
B. Fan speed button
D. Timer / Temperature up button
F. Fan low speed indicator
I. Sleep mode button
K. Cool mode indicator
M. Fan mode indicator
O. Oscillation button
S. Fan middle speed indicator
6