Worx WT525 Manual Del Usuario página 12

Fig 3
Fig 4
12
Fig 5
Fig 6
Cordless Circular Saw
NA-WT525-M-050727.indd 12
All manuals and user guides at all-guides.com
Warning: Blade teeth are very sharp. Wear gloves
when changing saw blades. For best cutting re-
sults ensure you use a saw blade suited to the material
and cut quality you need. Ensure the blade is suitable
for the rated speed of the tool. Only use carbide-tipped
blades in this tool.
6. DEPTH OF CUT ADJUSTMENT
Lift the depth of cut locking lever (13) and raise the saw
body away from the base plate (5). Set the depth of cut
using the scale (4) and push the lever down to lock (See
Fig 4). Always add 1/8" (3mm) to your depth of cut so
the blade can cut through the material. The riving knife
automatically adjusts position when the depth of cut is
changed.
7. BASE PLATE
Adjusting the angle of the base plate (5) enables bev-
el cutting. The base plate must always be held firmly
against the material being cut to reduce saw vibration,
blade jumping or blade breakage.
8. BASE PLATE ANGLE ADJUSTMENT
Loosen the base plate bevel lock knob (14) and rotate the
base plate (5) to set the bevel angle using the base plate
angle scale (6).Then clamp the base plate (6) in position
using the lock knobs (14) (See Fig 5). Finally, check the
angle and ensure the base plate is firmly clamped. The
angle markings on the angle scale are accurate for most
general purposes but it is recommended, for accurate
work, to set the angle with a protractor and make a test
cut on other material. Do not use the depth of cut scale
when making bevel cuts due to possible inaccuracy.
9. PARALLEL GUIDE ADJUSTMENT
The parallel guide is used for making cuts parallel to a
work-piece edge at a chosen distance. Slide the paral-
lel guide (7) arm through both fixtures to achieve the
required cutting distance and tighten screw to lock into
position (See Fig 6). It can be used from both sides of
the base plate (5). The cutting distance is shown on the
guide scale and by using the 90º or 45º notch edge on
the base plate (5). Always make a trial cut to check the
setting.
10. DUST EXTRACTION OUTLET
To remove sawdust, connect a suitable external dust ex-
traction device (e.g. vacuum cleaner) to the dust extrac-
tion outlet (8) using a flexible hose connection. Ensure
the hose connection is secure.
WT525
2005-7-27 17:46:07