Introduction; About This Manual; Units Of Measurement; Warranty - JCB XR Serie Manual Del Usuario

1

About this Manual

This document details the relevant use and maintenance
procedures for the JCB Trencher. The safety information
included is directly relevant to operation and maintenance
of the Trencher. General safety information, and that
relevant to the carrier machine is not included. For details
about safe operation of the carrier machine, see the
relevant documents.
DO NOT ATTEMPT TO INSTALL, OPERATE OR
MAINTAIN ANY ATTACHMENT UNTIL YOU HAVE READ
AND UNDERSTOOD ALL RELEVANT OPERATOR
DOCUMENTATION FOR BOTH THE ATTACHMENT, AND
THE CARRIER MACHINE.
ATTENTION TO SAFETY INFORMATION. YOU MUST
OBSERVE ALL RELEVANT LAWS AND REGULATIONS.
The manufacturer's policy is one of continuous
improvement. The right to change the specification of the
machine without notice is reserved. No responsibility will
be accepted for discrepancies which may occur between
specifications of the machine and the descriptions
contained in this publication.

Units of Measurement

In this manual, the S.I. system of units is used. For
example, liquid capacities are given in litres. The Imperial
units follow in parenthesis ( ), for example 28 litres
(6 UK gal/7.2 US gal)
JCB
Carrier
Robot 185 HF, 190HF, 1105HF, 1110HF
Robot 185, 190, 1105, 1110
Robot 170HF, 165HF, 160HF
Robot 170
Robot 165
Robot 160
Robot 150
1CX HF (208 HF USA)
1CX (208 USA)
All manuals and user guides at all-guides.com

INTRODUCTION

PAY PARTICULAR
XR-35
980/A1452
A1461-1

Warranty

A copy of the manufacturer's warranty is provided at the
rear of this manual. We advise you to read and understand
the warranty before using the machine.

Carrier Machine Suitability

The Trencher is suitable for use with the JCB Robot Skid
Steer Loaders and 1CX Backhoe Loaders according to the
following table
The Trencher is suitable for use with some other non JCB
carrier machines. See the specification section for details
of typical carrier requirements.
Note: If fitting XR35 onto an early JCB Mk1 Robot
185HF - 1110HF 1" Quick Release couplings were used
and the additional parts listed below are required, as
follows:
1 x 1406/0026 - 1in BSP Bonded Washer
1 x 45/910100 - 1 in BSP Female Quick Release Connector
1 x 1606/0012 - 1 in BSP - 3/4 in BSPMale-Male Adaptor
Trencher
XR-21 XR-14
980/A1451
980/A1451
980/A1450
980/A1450
980/A1450
980/A1450
980/A1451
980/A1450
1
Includes
USA
Machines