General Power Tool Safety Warnings - Makita DFL300F Manual De Instrucciones

ENGLISH
(Original instructions)
1 Battery cartridge
2 Red part
3 Button
4 Indicator lamps
5 Check button
6 Switch trigger
7 Reversing switch lever
8
Lamp
9 LED indicator
SPECIFICATIONS
Fastening torque
Square drive
No load speed (min
Overall length
(Depending on the battery)
Net weight
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest
combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for screwdriving in wood, metal and
plastic.

General Power Tool Safety Warnings

WARNING Read all safety warnings, instructions,
illustrations and specifications provided with this
power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
4
Explanation of general view
10 Screw
11 Angle head
12 Ring
13 Scale
14 Compression spring
15 Yellow line
16 Hole for adjust grip
17 Adjust grip
18 Socket
Model
Hard joint
Soft joint
–1
)
BL1415N / BL1415NA / BL1430 / BL1430B / BL1440 / BL1450 / BL1460A / BL1460B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
DFL300F
16 – 30 N•m
16 – 30 N•m
9.5 mm
400
456 – 473 mm
1.7 – 2.1 kg
ENE033-1
CORDLESS SCREWDRIVER SAFETY
WARNINGS
1. Hold the power tool by insulated gripping
GEA010-2
surfaces, when performing an operation where
the fastener
Fasteners contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not
immediately after operation; they may be
extremely hot and could burn your skin.
6. Always secure workpiece in a vise or similar
hold-down device.
SAVE THESE INSTRUCTIONS.
19 Hole
20 Pin
21 DFL300F
22 Range of fastening capacity
23 Revolution angle (°)
24 Torque (N•m)
25 DFL400F
DFL400F
25 – 40 N•m
25 – 40 N•m
9.5 mm
460 – 477 mm
1.8 – 2.1 kg
D.C. 14.4 V
may contact
touch the bit or
260
GEB139-1
hidden wiring.
the workpiece