LG WM9500H Manual Del Propietário página 47

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Problem
Power cord is not properly
plugged in.
Washer will not turn
House fuse is blown, circuit
on
breaker has tripped, or power
outage has occurred.
The washer automatically
adjusts the wash time for
Wash cycle time is
the amount of laundry, water
longer than usual
pressure and other operating
conditions.
Bleach dispenser cover is not
properly installed.
Bleach does not
dispense
Bleach dispenser is dirty or
clogged.
Premature
Bleach dispenser filled for
dispensing of
future load.
bleach
Detergent compartments
clogged from incorrect filling.
Too much detergent used.
Incomplete or
no dispensing of
detergent
Insufficient water supply.
Normal residue.
All manuals and user guides at all-guides.com
Possible Cause
Make sure that the plug is plugged securely into a
grounded, 3-prong, 120-VAC, 60-Hz outlet.
Reset circuit breaker or replace fuse. Do not increase
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician.
This is normal. The washer adjusts cycle time
automatically to provide optimal results for the selected
cycle. The time remaining shown in the display is only an
estimate. Actual time may vary.
Make sure that the bleach cover is properly installed and
snapped into place before the beginning of the cycle.
Lift out the bleach dispenser cover and clean out the
reservoir. Lint and other foreign debris that collects in the
inside the dispenser may prevent proper dispensing of
the bleach.
You cannot store bleach in the dispenser for future use.
The bleach will be dispensed every load.
Make sure that detergent and additives are put into the
correct dispenser compartments. For all detergent types,
always make sure that the dispenser drawer is fully
closed before the start of the cycle.
Make sure that the suggested amount of detergent is
used per the manufacturer's recommendations. You may
also dilute the detergent with water to the maximum fill
line on the compartment to avoid clogging. Use only HE
(High-Efficiency) detergent.
NOTE: Always use as little detergent as possible. High-
Efficiency washers need very little detergent to achieve
optimum results. Using too much detergent will cause
poor wash and rinse performance and may contribute to
odors in washer.
Make sure that both hot and cold water faucets are
turned on all the way.
It is normal for a small amount of detergent to remain
in the dispenser. If this residue builds up it can interfere
with normal dispensing of products. Refer to the cleaning
instructions.
TROUBLESHOOTING
Solutions
47

Capítulos

Tabla de contenido
loading

Tabla de contenido