Smart Thinq; Remote Start - LG WM9500H Manual Del Propietário

34 SMART FUNCTIONS
Product Registration and Wi-Fi Setup
1
Run the LG Smart Laundry & DW application on
a smart phone.
2
Select Smart Appliance.
3
Select Washer.
4
Select Front Load.
• If you see a pop-up message about NFC,
press the Cancel button.
5
Press the Wi-Fi model button at the bottom of
the screen.
6
Enter the email ID and password you registered.
If you don't have an account at http://
us.smartthinQ.com, press the Create an
account button and create a user ID and
password.
7
Select the Login button.
8
On the next page, the application shows the Wi-
Fi network list. Select your home network. If your
network requires a key, enter the password and
select the Connect button.
9
If the application successfully connects to the
home network, turn on the washer and then
press and hold the Wi-Fi Connect button on the
washer for three seconds.
After powering on the washer, do not press any
other buttons before pressing and holding the
Wi-Fi Connect button. The Wi-Fi connection
indicator on the washer blinks to indicate the
machine is connecting.
10
The application now works to connect the
appliance and register it as a Wi-Fi product.
A notification appears when the washer is
successfully set up and the product registration
and Wi-Fi setup is complete. The Wi-Fi
connection indicator illuminates when the
machine connects to the home network.
All manuals and user guides at all-guides.com
NOTE
• LG electronics is not responsible for any network
• The machine supports 2.4 GHz Wi-Fi networks
• Use the Settings menu in the application to register
• If the router or the router's password is changed,
• If the appliance is having trouble connecting to the
• The Wi-Fi connection may not connect or may
• The network connection may not work properly
• The surrounding wireless environment can make
• This information is current at the time of

Smart ThinQ™

Remote Start

Use a smart phone to control the appliance remotely.
Or monitor the cycle operation to see the remaining
time left in the cycle.
NOTE
• You must first connect to a gateway and register
• The Remote LED on the control panel should be
connection problems or any faults, malfunctions, or
errors caused by network connection.
only.
or change the machine. Select Settings > Change
Product > Add Product and then follow steps 2–10
above.
select Settings > Change Product > Add Product
and then follow steps 2–10 above.
Wi-Fi network, it may be too far from the router.
Purchase a Wi-Fi repeater (range extender) to
improve the Wi-Fi signal strength.
be interrupted because of the home network
environment.
depending on the Internet service provider.
the wireless network service run slowly.
publication. The application is subject to change for
product improvement purposes without notice to
users.
the appliance in order to use the Remote Start.
illuminated.