Know Your Unit - Remington RM1823BH Guia De Inicio Rapido

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

SAFETY INFORMATION
• A 2-wire extension cord (one without a ground) may be used. However, a 3-wire extension cord
(one with a ground) that uses a NEMA-type connector (parallel blade, U ground) is recommended.
Extension cords are available from local retailers.
• Make sure the extension cord is heavy enough to carry the current drawn by the unit. An
undersized cord will cause a drop in line voltage resulting in loss of power and overheating. If in
doubt, use the next heavier gauge cord. The smaller the gauge number, the heavier the cord.
MINIMUM WIRE SIZE FOR EXTENSION CORDS
FOR 120 VOLT APPLIANCES USING 0-10 AMPS
Cord Length (feet)
25
Wire Size (AWG)
18
• A nameplate on your unit indicates the voltage used. Never connect the unit to an AC voltage that
differs from this voltage.
• Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuit(s) or outlet(s) that
will be used with the unit. For an extra measure of safety, use receptacles with built-in GFCI protection.
HEDGE TRIMMER SAFETY
• DO NOT over reach.
• DO NOT cut above shoulder height.
• DO NOT operate the unit with one hand! Serious injury to the operator, helpers or bystanders may
result from one-handed operation. This unit is intended for two-handed use. Always grip the unit
firmly with both hands when the motor is running. Keep the left hand on the front handle and the
right hand on the rear handle. Use a firm grip with thumbs and fingers encircling the handles.
• DO NOT use the front hand guard as a handle.
• DO NOT operate the unit on unstable surfaces, such as trees, ladders, slopes or rooftops. Be very
careful when using the unit on stairs.
• DO NOT force the unit. It will do a better, safer job when used at the intended rate.
• DO NOT leave the unit unattended while the battery is installed. Remove the battery from the unit
when not in use.
• Inspect the work area before using the unit. Remove any hard and/or sharp objects, such as glass,
wire, etc. If thrown or caught in the trimmer blade, such objects could cause property damage or
injury to the operator or bystanders.
• If the unit strikes or becomes entangled with a foreign object, stop the motor immediately, remove
the battery and check for damage. Do not restart or operate the unit before repairing damage.
• Keep hair, loose clothing, fingers and all other body parts away from openings and moving parts.
• Keep proper footing and balance at all times.
• Before starting the unit, make sure the trimmer blade is not contacting anything.
• Always begin a cut with the motor running at full speed.
• Always stop the motor when operation is delayed, before setting down the unit or when walking
from one location to another. Make sure the unit comes to a complete stop.
• To avoid accidental starting, never carry the unit with fingers on the switch trigger.
• Always carry the unit by the front handle with the battery removed, finger off the switch trigger and the
trimmer blade positioned to the rear.
• Always make sure the switch lock is in the locked or OFF position before installing or removing the battery.
• This unit is intended for infrequent use by homeowners. It is not intended for prolonged use.
• For safer, more effective performance, make sure the trimmer blade is sharp, properly cleaned and
free from obstructions. Follow all lubrication instructions.
MAINTENANCE AND STORAGE SAFETY
• DO NOT operate a unit that is damaged, improperly adjusted or not completely and securely
assembled. Be sure that the unit stops when the trigger is released. Do not use the unit if the
switch does not turn the unit on and off properly or if the switch lock does not work. Have defective
switches replaced by an authorized service center.
• If the unit is not working as it should, has been dropped, damaged, left outdoors or dropped into
water, do not use the unit. Have the unit serviced by an authorized service center.
• All service, other than the maintenance procedures described in this manual, should be performed
by an authorized service center. Do not attempt to repair; there are no user serviceable parts inside.
• Follow all maintenance instructions in this manual.
• Before inspecting, servicing, cleaning, storing, transporting or replacing any parts on the unit:
1. Make sure the switch lock is in the locked or OFF position.
2. Make sure all moving parts have stopped.
3. Remove the battery.
4. Allow the unit to cool.
• Never remove, modify or make inoperative any safety device furnished with the unit.
• Frequently inspect the unit for damage. Before further use, any damaged part should be carefully
checked to determine that it will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts and any other conditions that
may affect its operation. Damaged parts should be properly repaired or replaced by an authorized
service center, unless otherwise indicated in this manual.
• If the unit starts to vibrate abnormally, stop the motor, remove the battery and allow the unit to cool.
Then inspect the unit for the cause of the vibration. Vibration is generally an indicator of trouble.
• Use only original manufacturer replacement parts and accessories, which are designed specifically to
enhance the performance and maximize the safe operation of the product. Failure to do so may cause
poor performance and possible injury.
• Remove the battery from the unit when not in use.
• Be sure to secure the unit while transporting.
• When not in use, store the unit indoors in a locked-up and dry, or high and dry, place to prevent
unauthorized use or damage. Keep out of the reach of children.
• Keep the handles dry, clean and free from debris, oil and grease. Clean the unit after each use.
Never douse or spray the unit with water or any other liquid. Do not wash the unit with a hose; avoid
getting water in the motor and electrical connections. Do not use solvents or strong detergents.
2
50
100
150
18
16
14
SAFETY INFORMATION
• SAFETY AND INTERNATIONAL SYMBOLS •
This operator's manual describes safety and international symbols and pictographs that
may appear on this product. Read the operator's manual for complete safety, assembly,
operating, maintenance and repair information.
SYMBOL
MEANING
• SAFETY ALERT SYMBOL
Indicates danger, warning or caution. May be used in conjunction with other symbols
or pictographs.
• READ OPERATOR'S MANUAL
WARNING:
safety instructions. Failure to do so can result in serious injury to the operator and/or
bystanders.
• WEAR EYE AND HEARING PROTECTION
WARNING:
and hearing loss. Wear eye protection meeting ANSI Z87.1-1989 standards and ear
protection when operating this unit. Use a full face shield when needed.
• KEEP BYSTANDERS AWAY
WARNING:
50 feet (15 m) from the operating area. If anyone enters the work area, stop the unit!
• WEAR SAFETY GLOVES
Wear non-slip, heavy-duty protective gloves when handling the unit.
• WEAR SAFETY FOOTWEAR
Wear non-slip safety footwear when using this equipment.
• SHARP BLADE
WARNING:
not touch the blade. Keep both hands away from the blade while operating the unit.
• DO NOT USE IN THE RAIN
WARNING:
the rain or in damp or wet conditions. Moisture is a shock hazard.
SAVE THESE INSTRUCTIONS

KNOW YOUR UNIT

APPLICATIONS
This unit may be used for the purposes listed below:
• Trimming and forming hedges, shrubs and bushes with a branch diameter of up to 7/16 of an
inch (11.1 mm).
NO TOOLS REQUIRED!
Blade Support
Rod
Front Hand
Guard
Upper Cutting
Blade
Lower Cutting
Blade
Read the operator's manual(s) and follow all warnings and
Thrown objects and loud noise can cause severe eye injury
Keep all bystanders, especially children and pets, at least
The blade on this unit is sharp. To prevent serious injury, do
Avoid dangerous environments. Never operate your unit in
Front
Handle
Switch
Lock
Battery
Release Button
Switch
Trigger
Rear
Handle

Capítulos

Tabla de contenido
loading

Tabla de contenido