Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Injector Puller Set for Bosch CDI Injectors
TOOLS
1 Sliding hammer bolt
External screw thread M16x1.5
2 Sliding hammer weight, 1650g, Ø79
mm
3 Adaptor for fuel line connection
Internal thread M16x1.5
4 Fastening screws, M12x1.0
for mounting the adaptor (3) in the fuel
line connection
5 Adaptor electromagnetic unit
Internal thread M27x1.0
Internal thread M16x1.5
6 Injector puller hook, 12.9 mm
with internal thread M16x1.5
INTENDED USE
This injector puller set is used to disassemble Bosch CDI injectors for e. g. Mercedes-Benz CDI
engines 611, 612, 613 and many other vehicle models. The sliding hammer can be adapted at three
different points of the injector using the included adaptors.
SAFETY INFORMATION
• Do not use the tool if parts are missing or damaged.
• Only use the tool for work that is specified under intended use.
•
Never place the tool on the vehicle battery. There is a risk of a short circuit.
•
Be careful when working with the engine running. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
•
Keep children and other unauthorized persons away from the work area.
•
Be careful when working on hot engines because of the risk of burn injuries.
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
•
Check whether all tools have been removed from the engine compartment after repair or before
starting.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
1
Tel.: 02196 720480
Fax.: 02196 7204820
Art. 9632
2
4
5
3
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
6
Tabla de contenido
