Attaching The Fan Blades - Home Decorators Collection 35442-HBUM Guía De Uso Y Cuidado

Assembly - Standard Ceiling Mount (continued)
7
Mounting the fan
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
□
Align the locking slots of the ceiling canopy (C) with the two
canopy screws (AA) in the mounting bracket (B). Push up to r
engage the slots and turn clockwise to lock in place.
□
Firmly tighten the two canopy screws (AA).
□
Install the two canopy screws (AA) (saved from Assembly
Step 1 "Preparing for mounting") into the holes in the
canopy (C) and tighten firmly.
AA
B
9
Installing the lamp
□ A wire connector (female) is located inside the electrical switch
housing and a male connector extends from the lamp. Push them
together.
□ A wire connector (male) is located inside the electrical switch
housing and a female connector extends from the lamp. Push them
together.
□ Place the lamp (H) into the electrical switch housing aligning the
three flat areas on the lamp (H) with the three raised dimples
in the lamp (H). Turn the lamp (H) clockwise until it stops.
8
□ Attach the fan blades (A) to the fan motor assembly (G)
□ Repeat these steps for the remaining blades (A).
AA
E
C
F
10

Attaching the fan blades

by using the blade screws (BB) and fiber washers (CC).
Tighten blade screws (BB) securely.
G
H
BB
CC
A
G