Automatic Shut-Off; Recovery Tank - Hoover Floormate Manual Del Usuario

Ocultar thumbs Ver también para Floormate:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
FM-Candy final
17/6/03
2-10
H
Turn cap (H) upside down to serve
as a measuring cup.
2-13
J
If rubber ring (J) on cap has become
dislodged, reposition it with uneven
side against ledge (K) as shown.
Recovery Tank (Lower Tank)
The recovery tank holds both dry
debris and dirty cleaning solution that
is picked up from the floor surface.

Automatic Shut-Off

An automatic suction shut-off is built
into the recovery tank to prevent the
tank from overflowing.
When the shut-off activates, the clean-
er will not pick up debris and the
sound of the motor will change.
There are two reasons the shut-off will
activate.
1. Recovery tank is full - Turn the
cleaner off and empty the recovery
tank.
2. The handle was raised to the
upright position while the motor
was running - Turn cleaner off. Wait a
moment for the shut-off to reset. Turn
cleaner on and continue cleaning.
4:54 PM
Page 7
All manuals and user guides at all-guides.com
2-11
Using tank cap, measure 60 ml. of
cleaning solution.
For best results, use Dettol Direct
Floor Cleaner Fresh Fragrance
when cleaning floor surfaces such as
vinyl, ceramic and other tiles, and
linoleum. Dettol Direct Floor Cleaner
Fresh Fragrance has been tested
and approved for diluted use with
'FloorMate'. If using any other floor
cleaning solution, dilute according to
solution manufacturer's instructions.
Never use more than one tank cap of
solution.
2-14
K
Replace cap. Rotate cap clockwise
until it locks in place. Cap must be
locked in place for proper perfor-
mance and to prevent leaking.
How to Empty
Turn cleaner off and disconnect
from electrical outlet.
Although not necessary for satisfacto-
ry performance, it is recommended
that the recovery tank be emptied
after dry vacuuming and before wet
operation.
Check the solution tank also. It may
need to be refilled at this time.
2-12
Pour cleaning solution into tank. Fill
tank to fill line (I) with warm water.
2-15
Position bottom of tank into cleaner.
Press latch and snap tank into place.
2-16
L
To remove tank, press down on
release button (L) and pivot tank for-
ward.
Continued
GB
I
7
Tabla de contenido
loading

Tabla de contenido