Safety Instructions - TECshow BLINDER LITE Manual De Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2. WARNING
For your own safety, please read this user manu-
al carefully before your initial start-up!
CAUTION!
Keep this equipment away from
rain, moisture and liquids.

Safety Instructions

Every person involved with the installation, opera-
tion and maintenance of this equipment should:
Be competent
Follow the instructions of this manual
CAUTION!
Take care using this equipment!
High voltage-risk of electric shock.
Before your initial start-up, please make sure that
there is no damage caused during transportation.
Should there be any, consult your dealer and do not
use the equipment. To maintain the equipment in
good working condition and to ensure safe opera-
tion, it is necessary for the user to follow the safety
instructions and warning notes written in this
manual. Please note that damages caused by user
modifications to this equipment are not subject to
warranty.
Important
The manufacturer will not accept liability for any
resulting damages caused by the non-observance
of this manual or any unauthorized modification to
the equipment.
Never let the power-cable come into contact
with other cables. Handle the power-cable and
all mains voltage connections with particular
caution!
Never remove warning or informative labels
from the equipment.
Do not open the equipment and do not modi-
fy the equipment.
Do not connect this equipment to a dim-
mer-pack.
Do not switch the equipment on and off in short
intervals, as this will reduce the system life.
Only use the equipment indoors.
Do not expose to flammable sources, liquids
or gases.
Always disconnect the power from the mains
when equipment is not in use or before clean-
ing! Only handle the power-cable by the plug.
Never pull out the plug by pulling the pow-
er-cable.
Make sure that the available voltage is 110-
240v.
Make sure that the power-cable is never
crimped or damaged. Check the euipment
and the power-cable periodically.
If the equipment is dropped or damaged, dis-
connect the mains power supply immediately.
Have a qualified engineer inspect the equip-
ment before operating again.
If the equipment has been exposed to drastic
temperature fluctuation (e.g. after trans-
portation) do not switch it on immediately.
The arising condensation might damage the
equipment. Leave the equipment switched off
until it has reached room temperature. Only
use fuses of same type and rating.
Repairs, servicing and power connection must
only be carried out by a qualified technician.
This unit contains no user serviceable parts.
P. 3
| Tecshow Blinder Lite
English version
Tabla de contenido
loading

Tabla de contenido