Product Features - HoMedics THERMAL PRO Guia De Inicio Rapido

PRODUCT FEATURES:

fig. 1
Heat Heat
Cool
Charging
indicator LED
On/off/power
button
Power socket
MASSAGE HEADS
HEAT Active thermal head relaxes tired aching muscles
INSTRUCTIONS FOR USE
Charging your device
1. To charge the product, plug the charging cable into a USB socket and connect
the cable to the charging socket on the bottom of the handle (fig.2).
2. Once the charging cable is connected, the charging indicator LED will
illuminate and blink red. As soon as the device is fully charged the LED
indicator will change to blue.
3. Once the product is fully charged, disconnect it from the power supply.
4. The product requires 5-6 hours of charging for a full charge and will last for
approximately 1 hour of use.
WARNING If the voltage input exceeds 5V, the massager will terminate charging
and the indicating light will blink in blue in order to remind the user to use the
correct voltage adaptor. Product should only be charged using the adaptor supplied
(DJ0500100-S11EU). Adaptor must be removed from the socket when not in use.
Adaptor output charging voltage of 5Vdc and 1A must not be exceeded.
Using your device
NOTE Remember to switch off the heat when you have finished using by
pressing the heat button (fig.4).
1. Select the desired massage head and fasten it into the socket on the front of
the massager (fig.3). It should be finger tight only as overtightening may
cause damage to the product.
2. Press and hold the power on/off/power level button for 3 seconds to turn
the device on.
3. Pressing the on/off/power button again will cycle through the power levels:
• Press x 1: LO
• Press x 2: MID
• Press x 3: HI
• Pressing the button again will repeat this sequence.
Operation
indicator light
USB charging cable
Storage bag
COOL Cooling calms inflamed stressed muscles
4. To use heat treatment with Heat massage head, press the heat button on the
back of the product once (fig.4). The red LED light ring on the Heat head will
illuminate. Press the power button to start the massage and adjust intensity
as above. NOTE Heat function only works with Heat massage head.
5. IMPORTANT Before using the Cool massage head, place in a freezer for
several hours.
6. Gently move the massage head over the part of the body you wish to massage
at first, then gently apply more pressure as desired. If you are a first time user
it is recommended that you start on power level 1 and press gently.
7. A long press on the on/off/power button for 1 second will turn the massager
off.
8. The product cannot be used while charging
DO NOT USE THE PRODUCT FOR OVER 30 MINUTES CONTINUOUSLY.
IF THE PRODUCT IS USED FOR OVER 30 MINUTES IT MAY TRIGGER THE
HEAT PROTECTION FEATURE AND STOP AUTOMATICALLY.
PLEASE WAIT FOR AT LEAST 30 MINUTES FOR THE PRODUCT TO COOL OFF
BEFORE RE-USING.
Cleaning your device
• Make sure the device is unplugged from any power supply and allow to cool
before cleaning. Clean only with a soft, slightly damp sponge.
• Never allow water or any other liquid to come into contact with the
appliance.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, glass/furniture polish, paint thinner,
etc to clean.
GB
2 I
fig. 2
fig. 3
Adaptor
fig. 4