Oven Positioning - Diamond LD4/35-N Manual De Instrucciones

2 INSTALLATION
Installation must be executed by qualified personnel in compliance with local, national and European
regulations.

OVEN POSITIONING

Ensure that the oven is put on a stand with the suitable carrying capacity and that is flat.
After unpacking the oven from its packing, position it in prepared location, taking into account the minimum
distances.
Remove possible protections in polystyrene and take off the protecting film (F) avoiding to use tools
which can damage the surfaces.
EQUIPMENT HOOK-UP
Electrical connection
The oven is not provided with power supply cable. When connecting the appliance electrically, an
automatic RCD must be interposed with an opening distance between contacts of at least 3 mm.
connect the appliance electrically it is essential to procede in the following way:

remove the right side panel;

connect to the terminal block the power cable.
The power supply cable must be of H07-RNF type, with approved minimum cross section as prescribed by
the specific directive.
The electrical outlet must be easy to access, no moving should be necessary.
! The electrical connection (plug) must be easily accessible, also following oven installation.
The distance between the machine and the socket must be adequate to not cause tension in the power
supply cable. In addition, the cable must not be located beneath the machine support base.
- 28 -
To