Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LUBRICATION & MAINTENACE
•
Oil the tool before each use with 4 to 5 drops air tool oil, placed in the air inlet is
sufficient.
•
Use proper air pressure and CFM rating listed for this tool.
•
Drain water from hoses and compressor tank.
•
Water in the air supply system damaged the tool and loss of power.
•
Clean or replace air filters at prescribed intervals from.
TROUBLESHOOTING
Probable Cause
Dirty or clogged air passages
Insufficient air supply
Air leakage
Worn/damaged wear & tear parts
Tool matching
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All
tools, accessories and packaging must be sorted, taken to a recycling
point and disposed of in an environmentally friendly manner.
DISPOSAL
Dispose of this product at the end of its service life in accordance with
your region's disposal regulations. Ask your local waste agency about
recycling measures.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
(Insufficient power)
Flush and lubricate tool, drain air tank and supply line
Increase line pressure, make sure compressor
matches tool's air pressure and consumption needs
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Replace as necessary
Be sure you are using a tool suited for the sanding
requirements of the job at hand.
Tel.: 02196 720480
Fax.: 02196 7204820
Solution
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
