Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USE
Oil tool before each use 4 to 5 drops of a good grade Air Tool Oil placed in
proper air pressure and CFM rating listed for this tool.
1. To set the tool to desired torque, select a nut or screw of known tightness of the same size, thread
pitch and thread condition as those on the job.
2.
Turn air regulator to low position, apply wrench to nut and gradually increase power (turn regulator to
admit more air) until nut moves slightly in the direction it was originally set. The tool is now set to
duplicate that
tightness.
3.
Do not tighten nuts or screws with higher torque than allowed. Put nut or screw in the thread and start
attach several revolutions by hand. With the impact wrench tighten the screw until it rests flush against
the supporting surface.
TROUBLESHOOTING
(Insufficient power)
Probable Cause
Dirty or clogged air passages
Insufficient air supply
Air leakage
Worn/damaged wear & tear parts
Tool matching
ENVIRONMENTAL PROTECTION
Dispose of this product at the end of its working life environmentally.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories
and packaging should be sorted, taken to a recycling centre and disposed of in a manner
which is compatible with the environment. Contact your local solid waste authority for
recycling information.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
All bolts must always be checked with a torque wrench after installation.
Flush and lubricate tool, drain air tank and supply line
Increase line pressure, make sure compressor matches tool's
air pressure and consumption needs
Use teflon tape at all fittings and joints.
Check tool for worn or damaged o-rings & seals.
Replace as necessary
Be sure you are using a tool suited for the sanding
requirements of the job at hand.
6
e
s
s
a r t S
h
c
s
m
e
R
Solution
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
the
air inlet is sufficient. Use
L
d . l h
a t s
w
s
@
o f n i
: l i
Tabla de contenido
