Stryker VisionPro Manual Del Usuario página 6

5� To connect to an international power supply, use an attachment plug appropriate for the
power outlet, as outlined in the "Technical Specifications" section of this manual�
6� Unplug the device if it is not to be used for an extended period of time� To disconnect the
cord, unscrew the plug first, then pull the cord out by the plug� Never pull the cord itself�
7� Do not expose the device to moisture or apply liquid cleaners directly to the screen� Spray
the cleaning solution onto a soft cloth and clean gently� For further detail, refer to the
"Cleaning and Maintenance" section of this manual�
8� Allow adequate air circulation to prevent internal heat buildup� Do not place the device
on surfaces (rugs, blankets, etc�) or near materials (curtains, draperies) that may block the
ventilation slots� The device is cooled by natural convection and has no fan�
9� Do not touch the patient with signal input or output connectors� Equipment with SIP/
SOP connectors should either comply with IEC 60601-1 and/or IEC 60601-1-1 harmonized
national standards or the combination should be evaluated for safety�
10� To ensure electromagnetic compatibility, refer to the "Electromagnetic Compatibility" section
of this manual� The VisionPro 26" LED Display (0240-031-020) and the VisionPro SYNK 26"
Wireless LED Display (0240-031-000) must be installed and operated according to the EMC
information provided in this manual�
11� Pay close attention to the cleaning instructions in this manual� A deviation may cause
damage�
12� Do not install the device near sunlight, excessive dust, mechanical vibration, or shock�
13� Do not position the device so that it is difficult to disconnect the power cord from the supply
mains�
14� Do not operate with the glass device screen facing downward�
15� Handle the device with care� Do not strike or scratch the screen�
16� Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the device�
17� Note: This device has been tested and found to comply with the limit for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
device generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. There is no guarantee that interference will not occur in a particular
installation, which can be determined by turning the device off and on. The user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving device.
•
• Increase the separation distance between the device.
• Connect the device to an outlet on a circuit different from that to which the other
device(s) are connected.
Consult the manufacturer or field service technician for help.
•
The warranty is void if any of these warnings or cautions are disregarded�
This product contains electrical waste or electronic equipment� It must not be disposed of as
unsorted municipal waste and must be collected separately�
EN-2