Assembly - Hanging the Fan (continued)
3
Setting the code on the remote
control and receiver
NOTE: The frequencies on your receiver and hand unit have
been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and hand unit are
set to the same frequency. The dip switches on the hand unit
are located inside the battery compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
hand unit. Dispose of used battery properly and keep the
battery out of the reach of children.
□
Remove the remote control (J) battery cover by pressing
firmly on the arrow and sliding the cover off.
□
Slide the dip switches (ZZ) to your choice of either up or
down. The factory setting is up.
□
Slide the dip switches (ZZ) on the receiver (I) to the same
position as set on the remote control (J).
□
Install the 23A 12V battery (L).
□
Replace the battery cover on the remote control (J).
□
Insert the silicone rubber stopper (OO) into the hole on the
receiver (I) to cover the dip switches.
I
J
ZZ
ON
OO
1
2
3
4
4
Installing the receiver
WARNING: To reduce the risk of fire or electric shock,remember
to disconnect power. The electrical wiring must meet all local
and national electrical code requirements.The electrical source
and fan must be 110/120 volt, 60Hz. Do not use this product
in conjunction with any variable wallcontrol. Incorrect wire
connection can damage this receiver.
CAUTION: If other fan wires are a different color, have this
unit installed by a licensed electrician.
□
Position the house supply wires (AAA) to one side of the slide-
on mounting bracket (A); position the fan wires (BBB) to the
opposite side.
□
Insert the narrow end of the receiver (I) (as shown, flat side
towards the ceiling) into the slide-on mounting bracket until it
rests on top of the ball/downrod assembly.
Hanging the fan
AAA
9
Please contact 1-800-986-3460 for further assistance.
A
I
BBB
A
HOMEDEPOT.COM/HOMEDECORATORS
B
C