Craftsman WEEDWACKER 316.790130 Manual Del Usuario página 13

3. Insert the line into the locking hole no more than
1/2 inch (12.7 mm) (Fig. 16). Do not push the line too
far into the inner reel. A small loop is formed when
the line is inserted correctly.
4. Pull the line away from the head until the line is tight
against the reel (Fig. 17).
5. Repeat the procedure with the second eyelet and
use the same amount of line as specified in Step 2.
6. Wind the inner reel counterclockwise until approxi-
mately four (4) inches of line remains outside of the
eyelets in the reel housing (Fig. 18).
7. If winding the line becomes difficult or the line jams,
pull the ends of the line away from the head and
continue winding the reel counterclockwise (Fig. 19).
Releasing the reel
If the RapidRewind Head does not operate correctly
when bumping the head on the ground, use the follow-
ing instructions.
1. Pull the ends of the line firmly away from the head
to release the reel (Fig. 19). If this procedure
does not release the reel, follow the "Cleaning the
RapidRewind" instructions below.
Cleaning the RapidRewind
If the RapidRewind Head becomes difficult to wind or
does not operate correctly when bumping the head on
the ground, use the following instructions.
1. If you need to remove the Bump Knob to clean
the head or remove jammed, excess line, hold
the reel housing, and unscrew the Bump Knob
counterclockwise (Fig. 20).
Locking Hole
Fig. 16
– 13 –
Fig. 17
Fig. 18
Fig. 19
Fig. 20