Programming - wissner-bosserhoff SafeLift Manual De Instrucciones

4.7 Programming

To connect
This function is used to transfer the coding of the controller to the box. A maximum of 23
controllers can be programmed. Pressing the LC key for 1-5 seconds starts the programming
process. The status LED flashes red/green for a total duration of 30 seconds.
The controller is programmed for the cor-
responding box in 3 steps:
1. Hold the LC button on the top of the
SafeLift Box until the LED flashes red/
green.
2. Press the GO button to activate.
3. Press a key on the left rocker switch
and then press two cross keys simul-
taneously.
If the coding has been transmitted, the status LED lights green as confirmation and the floor
lighting goes on for 3 seconds. If the controller has already been programmed, the status LED
lights green as confirmation and the floor lighting goes on for 1 second.
To separate
This function is used to delete all controllers from a box. It is not possible to delete individual
controllers. Press the LC button for at least 5 seconds until the status LED stops flashing. If
the deletion of the encodings has been transmitted, the status LED lights up permanently red.
If several controllers have been programmed, the adjustment keys may only be
operated by the same controller from which the GO button was operated. During an
active adjustment process, all signals from other controllers are ignored.
Attention!
SafeLift may only be operated with the handset connected and the controller
permanently mounted on the handrail.
SafeLift Box
3
2
1
3
SafeLift Controller
41