Alignment Marks - Utilitech AMQV2-28 Manual De Instrucciones

BULB REPLACEMENT INSTRUCTIONS
DANGER: RISK OF ELECTRIC SHOCK. Turn off power before replacing bulb.
Your light fixture comes with a 120-volt, 100-watt Type GY8.6 bulb pre-installed inside each lamp
head. To replace the bulb, carefully rotate the outer lamp housing so that the alignment marks on the
lamp housing line up with each other. Once the marks are aligned, gently pull the front of the lamp
housing away from the fixture to access the bulb. To remove the bulb, use soft cloth or tissue and
gently pull the bulb from the socket. Use tissue or a soft cloth to handle the new bulb and carefully
insert the new bulb into the socket. DO NOT touch the bulb with your bare hands. Wipe any finger-
prints from the bulb surface with alcohol. Reinstall the outer lamp housing over the bulb. Replace only
with 120-volt, 100-watt Type GY8.6 bulb or lower wattage bulb.

Alignment Marks

Printed in China
V-12-09
Utilitech & UT design® is a registered
trademark of LF, LLC. All Rights Reserved.
6
Lowes.com