Alternator Check; Care And Maintenance - Black and Decker BBC02 Manual De Instrucciones

All manuals and user guides at all-guides.com
Connecting the Charger with Terminal Rings
The charger's output leads have crimped, color-
coded ring terminals (Figure 4) (REDPOSITIVE
NUT
and BLACK-NEGATIVE). These rings connect
TERMINAL RINGS
directly to the corresponding connectors on the
battery posts.
CONNECTOR
1. Remove the nuts from the bolts of the battery
post's connectors.
BOLT
2. Position the RED terminal on the bolt of the
POSITIVE battery post connector.
3. Position the BLACK terminal on the NEGATIVE
post connector; then replace the nuts.
Figure 3. Ring Terminal Connection Diagram
4. If there is any problem connecting the output
leads, check with a reputable auto supply store or contact the Authorized
RED
Service Center nearest you for assistance in finding an appropriate connection
device for your particular application.
Note: ALWAYS disconnect the AC power cord from the AC power outlet before
connecting (or disconnecting) the charger to (or from) the battery.
BLACK
Figure 4. Terminal Rings
Charging the Battery
The charger's output leads also contain a DC accessory plug (Figure 5).
1. Insert the DC plug into the vehicle's DC accessory outlet.
2. Insert the AC plug of the charger into any standard AC wall outlet.
Note: Some vehicles require that the ignition be turned to the ACC (accessory)
position to acitvate the DC accessory outlet.
Figure 5. DC Accessory Plug

Alternator Check

1. Slide the Charge Rate Selector switch to 1 amp or 2 amps.
2. Leave the charger on.
3. Monitor the battery from time to time.
Note: A clicking sound may occur during this process. This is normal.
Fuse Replacement (DC Accessory Adapter)
1. Remove plug from accessory outlet. Remove the gold cap by turning counterclockwise and lifting off.
2. Remove center pin and spring. Remove fuse.
3. Replace fuse with same type and size fuse (5 amp).
4. Replace center pin and spring inside plug.
TROUBLESHOOTING
5. Replace gold cap by turning clockwise.
Unit Not Charging
• Check that the charger is properly connected to a live AC outlet (the LED will illuminate).
• Check that the correct charge rate has been selected for the battery being charged.

CARE AND MAINTENANCE

• If the battery to be charged has fallen below 4 volts, the battery cannot be recharged with this unit.
With proper care and minimal maintenance, the 1-2 Amp Charge Rate Automatic Battery Maintainer will provide years
of dependable service. For maximum performance, manufacturer recommends:
1. Storing the unit in a clean, dry, cool place when not in use.
2. Cleaning the unit casing and cords (as necessary) with a dry (or slightly damp) cloth. Ensure that unit is completely
disconnected from battery and power source, before cleaning.
3. To maintain the operating condition and maximize the life of the charger cords, always coil them loosely for storage.
Do not wrap them around the unit or crimp them with a tight band.
23