Change Faucet & Eyewash Direction - Bradley Halo S19-500 Serie Manual De Instrucciones

Installation
Change Faucet & Eyewash Swing Direction
A
From the bottom of the unit, remove the two
Phillips head screws to allow the top spout
assembly and cover to slide up and be removed.
B
Verify the eyewash is in the On position as
shown.
C
Remove the wave washer from on top of the rear
gear. Set aside for reinstallation.
D
Reposition the pin at the front hole marked with
the L or R. Refer to the illustration.
E
Slide the rear gear up and off of the post. Flip the
rear gear as needed per the illustration.
Slide the rear gear back on to the post, aligning
F
the gear teeth to fit with the small center gear.
Verify the L or R on the rear gear matches the pin
position used.
Test the eyewash rotation. Verify the eyewash
G
movement is stopped by the pin in each direction.
If it is not stopped, adjust the rear gear to engage
with the correct teeth.
H
Slide the wave washer back into position on top of
the rear gear.
I
Move the eyewash to the Off position by rotating it
to the right or left side.
J
Reassemble the top spout assembly and cover
and secure using the two Phillips screws removed
in Step A.
Check the function of the unit by swinging the
K
eyewash assembly from the On position to the Off
position. Verify the faucet is free to rotate. Move
the eyewash to the On position and verify the
faucet swings out of the way.
Bradley • 215-1910 Rev. D: ECO 21-05-013
S19-500 Series & S19-505 Series
Top Spout
Cover
Eyewash
Phillips Head
Screws
0.2"
Rear
Gear
Center
Gear
Pin
S19-500
7/6/2021
0.2"
S19-505
15