Assembly; Assembling Engine And Driveshaft Assembly; Loop Handle Installation; Connecting Stop Switch Wires - Maruyama B23C Manual Del Propietario Y Operador

Assembly

Assembling Engine and Driveshaft
Assembly
The driveshaft, clutch drum housing and gearcase are
assembled. Attach the clutch drum housing to the
engine using the four M5 x 20 screws supplied with the
unit.

Loop Handle Installation

The loop handle kit contains a package of four screws
and nuts, a rubber sleeve and the bottom clamp for the
loop handle.
Screw (4)
Nut (4)
1. Slip the rubber sleeve around the shaft approxi-
mately 9 inches (22.8cm) from the end of the stop
switch/throttle trigger assembly.
2. Rotate the rubber sleeve so the split is to one side.
3. Place the loop handle and the bottom clamp over
the rubber sleeve.
All manuals and user guides at all-guides.com
Loop Handle
Rubber Sleeve
Bottom Clamp
4. Install the four screws and nuts. Leave the screws
fingertight.
5. Reposition the loop handle up or down the driveshaft
to the most comfortable position, but no closer than 9
inches (22.8 cm) from the end of the stop switch.
6. Tighten the screws and nuts.

Connecting Stop Switch Wires

― US-9 ―