Taking A Measurement - Powerfix Profi HG01701C Instrucciones De Utilización Y De Seguridad

Note: The measuring pins are sharp and
may dent or damage the surface.
Rub the damp residue on the surface before
taking the measurement.
Measure several places and take an average
value.
Be aware that salts can increase the conduc-
tivity of water. This can lead to incorrect
readings and results that are too high.
Remove the bark from firewood if needed.
Press the measuring pins against the grain in
various places on the wood.

Taking a measurement

Press the button to switch on the
5
moisture measuring device. On the display
7
‚0.0%', the surrounding temperature in °C
and the previously selected material (1–6)
appears.
Press the button and hold it down for
4
approximately 5 seconds to switch the tem-
perature display between °C and °F.
If the display does not show ‚0.0 %' after
switching it on, you can calibrate the device.
Do this as follows:
Open the battery compartment , remove
6
the batteries and press the RESET button with
a pointed object, this button is on the bottom
of the device in the middle.
Press the MODE button
again to set the
3
moisture measuring device to the material
you wish to measure.
GB/IE 25