Velleman CU2200 Manual Del Usuario página 9

• SMS Message Contents
Command 8 is used to program the alarm message contents. The CU2200 will reply to the mobile
phone with the programmed message for that alarm channel.
Command: PWD:XXXX,READYTEXT%
• Commanding the CU2200 to Send SMS Message
This command is used to make the CU2200 to send the SMS message for testing purposes.
Command: PWD:XXXX,SENDMSA:XB%
XXXX
A
XB
Example:
PWD:1234,SENDMS4:09,Good Morning%
Password
SMS message "Good Morning" will be sent to phone number 4.
Error message about setting A:
Number Choice Miss
Number Non Exist No phone number is preset in that location
Error message about setting XB
Did not specify SMS contents
Reply confirmation message:
Success!:
Failed!:
• Relay Output Control
Command: PWD:XXXX,COUTN:Y%
Password
N
Y
The relay output is N.O. by default.
Command COUTN:1 is not valid when the relay output is triggered by alarm. Reply message will be
ST:XXX in this case.
In the above case, command COUTN:0 is used to reset the relay output after the alarm is triggered.
• Relay Output Delay Time
Command: PWD:XXXX,OUTNDLAY:YYYY%
XXXX
N
YYYY
The relay output delay time is good for controlling e.g. an electric door lock.
20.06.2011
XXXX Password
Y Alarm channel number (1 ~ 8)
Password
Phone number (1 ~ 8)
SMS message selection
00: schedule health check status
01:closed triggered alarm channel 1, SMS message
02: closed triggered alarm channel 2, SMS message
03: closed triggered alarm channel 3, SMS message
04: closed triggered alarm channel 4, SMS message
05: closed triggered alarm channel 5, SMS message
06: closed triggered alarm channel 6, SMS message
07: closed triggered alarm channel 7, SMS message
08: closed triggered alarm channel 8, SMS message
09:manual input message
10:Low voltage alarm message
11:AD channel 1, SMS message
12:AD channel 2, SMS message
13:Open triggered alarm channel 1, SMS message
14: Open triggered alarm channel 2, SMS message
15: Open triggered alarm channel 3, SMS message
16: Open triggered alarm channel 4, SMS message
17: Open triggered alarm channel 5, SMS message
18: Open triggered alarm channel 6, SMS message
19: Open triggered alarm channel 7, SMS message
20: Open triggered alarm channel 8, SMS message
1234
A is not within 1 ~ 8
XB is not within 00 ~20
CU2200 succeeds in sending message.
Operation failed but phone number exists.
1234
Relay output channel (1 ~ 3) (outputs 2 and 3 not available)
1 Turn on (close) the output
0 Turn off (open) the output
Password
Relay output channel (1 ~ 3) (outputs 2 and 3 not available)
0000 – 9999 seconds
0000 Turn the output on or off (default)
0005 Turn on the output for 5 seconds and off again
Turn off the output for 5 seconds and on again
CU2200
9
v3-01
©Velleman nv