Tabla de contenido
Idiomas disponibles
Idiomas disponibles
must be made following standard practice. To correctly adjust the extraction grilles, distribute 90% of
the air blown into the premises between all of the rooms.
Measures must be taken to avoid gas backdrafts in the room from the exhaust pipes of gas appliances
or other open fire appliances (for the duct fans and the partition wall fans).
All other extraction devices installed under other regulations (e.g. gas appliances) must not be altered.
3.5 Door undercuts
Undercuts must be made under all doors in the premises. The space required between the floor and
the bottom of the door is as follows:
▪
1 cm for all doors including the kitchen door if it has at least 2 access doors.
▪
2 cm for the kitchen door if it has only one access door and for all doors to rooms equipped
with an appliance connected to the gas.
3.6 Sensor installation location
3.6.1
Preferred locations within a domestic or commercial environment
The recommendation is to install the sensor:
-
At least 1 metre from the ground if the sensor is placed on furniture or on a shelf (using the
removable stand supplied with the INSAFE+ Carbon model)
-
At least 1.5 metres from the ground if the sensor is wall-mounted (attached with screws and
wall plugs)
To obtain data as close as possible to the user, we advise sticking to the recommended locations.
3.6.2
Locations to avoid
Do not install the indoor air quality sensor:
-
Less than 30 cm from the ceiling
-
Outside
-
In an area where the temperature is below 0°C or above 50°C
-
In an area where the humidity is greater than 95%
-
In a dusty or dirty area (garage, workshop, etc.)
-
At least 1 m from any doors and windows or any heating, cooling or air vents
-
In a walkway where it could get damaged
-
In a confined space (for example, in a cupboard or behind a curtain)
-
In an area where it could be obstructed (for example by furniture)
3.6.2.1
Precautions and usage restrictions for the sensor
-
Do not install the sensor in any of the situations described in the "Locations to avoid"
section.
-
Do not paint the sensor or cover it.
-
Do not block the sensor openings.
-
Do not disassemble, modify or damage the sensor.
23
Capítulos
Tabla de contenido
