MBM GBR77 Instrucciones Para El Funcionamiento página 36

5. 3.
INSTRUCTIONS FOR USE
Switching On/Off
When lighting for the first time, wait for the pos-
sible formation of air inside the gas circuit to fully
escape from the duct.
When the operations described on the previous page have
been performed successfully, do as follows to begin cooking:
Turn the knob (Fig. 7 A) to "1". When the green light is on (Fig.
7 B) it confirms the operating phase.
Turn the knob while holding it in the piezoelectric position
(Fig. 8 E) until the pilot light is lit.
After approximately 20" look to see if the pilot light remains lit
(Fig. 9). If so, release the button.
The pilot light can be seen through the hole on the panel.
Then turn it to the burner ignition position (Figure 8 F). Check
to make sure the pilot light remains lit (Fig. 9).
Repeat the operation if after 20" the pilot light is
not yet lit. If the pilot light does not ignite, contact
the technical assistance Centre.
When the pilot light has been lit, turn the thermostat knob to
the desired position (Fig. 8 D) to set the cooking temperature.
When the yellow indicator light is on it means that the heat-up
phase is in progress (Figure 7 C).
Turn the thermostat knob to "Zero" (Fig. 8 D) to switch the
burner off.
When the work cycle is over, in order to speed up
a new production cycle, you may turn the burner
off while leaving the pilot light on.
Turn the valve to "0" (Fig. 8 G) and the knob to "0" (Fig. 7 A) in
order to completely stop the appliance.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
- 900-980
D
- 14 - - 14 - 14 14
A
B C
7
Fig.
E F G
8
Fig.
9
Fig.