Dirt Container & Filter: Removal & Replacement; Belt Or Brush: Removal & Replacement - Dirt Devil M086700W Manual De Instrucciones

DIRT CONTAINER & FILTER: REMOVAL & REPLACEMENT
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
NOTE: Unplug cleaner before changing filter.
NOTE: For best performance, replace filter yearly.
FILTER TYPE
For F1 filter replacement (Part # 3-JCO280-000), please call 1-800-321-1134 or
F1
visit our website at www.dirtdevil.com to locate a dealer nearest you.
EMPTY AND CLEAN DIRT CONTAINER
2.
1.
Press latch above dirt container Remove dirt container lid.
and remove dirt container from
cleaner.
4. 5.
Clean filter and empty dirt Return filter to dirt container.
container completely. See Push filter into place to prevent
"Regular Maintenance" note dirt leakage.
below for instructions on container to cleaner (see
cleaning the filter. Page
Container).
*REGULAR MAINTENANCE: Each time the dirt container is emptied, the filter should be cleaned. Tap the filter
firmly against the inside of a trash can until the dirt stops falling from the filter. (Filter will be discolored after use,
this will not affect the filter's performance.) Do not brush the filter. The cleaning instructions may vary depending
on the dirt conditions. In some cases, more or less cleaning of the filter may be required. It is recommended that
the F1 filter Part # 3-JCO280-000 be replaced once per year. Please use reminder label located on filter
cap to record replacement date.
All manuals and user guides at all-guides.com
3.
Hold the dirt container and
grasp the top of filter. Twist
and pull the filter up and out.
Return dirt
7, Install Dirt
9
BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG CLEANER BEFORE CHANGING BELT
OR BRUSHROLL.
BELT STYLE
For Belt Style 5 replacement, please call 1-800-321-1134 or visit our website at
5
www.dirtdevil.com to locate a dealer nearest you.
TO REMOVE BELT
1.
Lay cleaner flat and flip cleaner to expose
nozzle base. Base should lay flat and
face up. To remove nozzle guard, use
Phillips screwdriver to remove the three
(3) screws. Arrows show location of
screws.
TO REPLACE BELT OR BRUSHROLL
4. 5.
MOTOR SHAFT
Slide belt onto motorshaft. Place new belt in area of
brushroll without bristles.
7. 8.
Reattach nozzle guard. Secure by aligning the three
(3) tabs in the base slots.
2. 3.
Pull and lift nozzle guard off. Lift and remove brushroll.
Dispose of old belt.
6.
6a.
Rotate brushroll manually to make sure belt is
properly aligned.
9.
SLOTS
TABS
Replace all three (3) screws
to secure nozzle guard.
10
With new belt in
place, pull and
slide brushroll
into nozzle
making sure
that the
brushroll end
caps are in the
correct orientation
(6a inset).