Above Floor Cleaning; Lightbulb Removal And Replacement; General Maintenance - Dirt Devil M085806 Manual Del Propietário

LIGHTBULB REMOVAL AND REPLACEMENT
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR
REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321-
1134 or your local auto parts store.
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
1. 1a.
Depress latch to remove dirt container
from cleaner. Remove the two (2) screws
located on the inside of the (Diagram 1).
Remove lens (Diagram 1a).
GENERAL MAINTENANCE
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
IF OBSTRUCTION DEVELOPS DURING FLOOR CLEANING:
1. If obstruction develops while cleaning carpets, turn cleaner OFF and unplug. Check to see if dirt cup is full
( Diagram 1); empty if needed (Page 9).
2. Check dirt path window and lower hose (Diagram 2). Remove any obstruction.
3. T urn cleaner over and remove nozzle guard (Diagram 3). Clear any obstruction that occurs in or around
the brushroll area.
IF OBSTRUCTION DEVELOPS DURING ABOVE FLOOR CLEANING:
1. If obstruction develops while above floor cleaning, turn cleaner OFF and unplug. Check to see if dirt cup
is full; empty if needed (Page 9).
2. C heck airflow areas of hose (Diagram 4). If there is no suction, disconnect hose, drop quarter through end. If
quarter comes out, there is NO blockage.
1. 2.
DEBRIS REMOVAL/POWER BRUSH TOOL
1. 2.
O RING
Turn the Turbo Tool/Power Pivot lower housing and
Brush over and slide off the remove clog.
O-ring.
2. 3.
Pull bulb out of socket to Replace lens. Secure the
remove. Do NOT twist. headlight lens by replacing
Gently push new bulb into the two (2) screws.
socket to replace.
3. 4.
3.
To reassemble, be sure tabs are engaged. Pivot
the lower housing closed. Slip the O-ring into the
groove at the neck of the Turbo Tool/Power Brush
to complete reassembly.
11