Tabla de contenido
IMPORTANT After replacing the chain,
its tension level must be checked more
frequently due to settling of the chain.
7.10 GUIDE BAR MAINTENANCE
NOTE
Any work on the guide bar requires
specific experience and special tools in order
to achieve top workmanship standards; for
safety purposes, we recommend you contact
your dealer to ensure work is done correctly.
To avoid asymmetrical wear on the bar,
make sure it is turned over periodically.
To keep the bar in perfect working
order, proceed as follows:
1. Grease the bearings on the nose sprocket
(if present) with the syringe (not included).
2. Clean the bar groove with the scraper
(not included) (Fig. 24.A).
3. Clean the lubrication holes (Fig. 24.B).
4. With a flat file, remove burr from the
edges and level off the guides.
7.10.1 Replacing the bar
Replace the bar whenever:
• The groove is not as deep as the height of the
drive links (which must never touch the bottom).
• The inside of the guide is worn enough
to make the chain lean to one side.
8. STORING
IMPORTANT The safety regulations to
follow for putting into storage are described
in paragraph 2.4. Strictly comply with these
instructions to avoid serious risks or dangers.
8.1 STORING THE MACHINE
When the machine is to be stored away:
1. Remove the battery from its housing
and recharge it (par. 7.2.2).
2. When the cutting means has
halted, mount the bar cover.
3. Allow the motor to cool before
storing in an enclosed space.
4. Clean (par. 7.4).
5. Check there are no loose or damaged
components. If necessary, replace the
damaged components and tighten
any screws and loose bolts or contact
the authorised service centre.
6. Store the machine:
– in a dry place
– protected from inclement weather
– in a place where children cannot get to it
– making sure that keys or tools used
for maintenance are removed.
8.2 STORING THE BATTERY
If the battery is not chargerd for a long period
of time, it must be kept in a cool, shaded
place without humidity, with environmental
temperature between 0~45°C.
NOTE
If unused for any length of
time, recharge the battery every two
months to prolong its working life.
9. HANDLING AND TRANSPORTATION
Whenever the machine is to be handled,
raised, transported or tilted you must:
1. Stop the machine
2. Wait until the chain is stationary
3. Remove the battery from its
housing and recharge it
4. Mount the bar cover
5. Wait until the motor is sufficiently cold
6. Wear heavy work gloves
7. Only hold the machine using the hand
grips and position the bar in the opposite
direction to that used during operation
When transporting the machine
on a vehicle, always:
1. Fasten the machine securely
with cables or chains
2. Position it so that it does not
cause a hazard to anyone.
10. ASSISTANCE AND REPAIRS
This manual provides all the necessary
information to run the machine and for
correct basic maintenance operations
which can be performed by the user. Any
regulations and maintenance operations
not described herein must be carried out by
your Dealer or Authorised Service Centre.
Any operations performed in unauthorised
centres or by unqualified persons will totally
invalidate the Warranty and all obligations
and responsibilities of the Manufacturer.
• Non-original parts and attachments are
not approved; use of non-original spare
parts and attachments will jeopardise
the safety of the machine and relieve the
Manufacturer from all obligations or liabilities.
• Original spare parts are supplied by authorised
Dealers and by Authorised Service Centres.
11. WARRANTY
EN - 13
Tabla de contenido
