Checking The Esst Feature - Stryker X8000 Light Source Manual Del Usuario

Checking the ESST Feature

The X8000 is equipped with Electronic Scope Sensing Technology (ESST), a
special safety feature that helps prevent accidental fires or burns to the patient or
user caused by a light cable not connected to a scope. This feature will only work
if the X8000 is used with an ESST light cable. When operated with an ESST light
cable, the X8000 senses when the scope and light cable are separated, and places
the light source in Standby mode. In Standby mode, the X8000 will reduce light
output to a minimum, preventing the light cable from generating excessive heat.
To verify the ESST feature is active, perform the following test before every
surgical procedure:
1. Set up the X8000 system with an ESST light cable and scope, and then
power on the system.
2. Place the X8000 in Run mode.
3. Remove the light cable from the ESST scope adapter.
The X8000 should return to Standby mode, indicating that the ESST feature is
functioning properly.
W A
ARNING
STANDBY MODE
THE UNIT FAILS TO RETURN TO
FAULT WITH THE
ESST
W E
ARNING
STANDBY MODE
LIGHT CABLE ADAPTER DIRECTLY ON THE PATIENT
OTHER FLAMMABLE MATERIAL
T
LIGHT CABLE TIP WILL TAKE SEVERAL MINUTES TO COOL OFF
AFTER BEING PLACED IN STANDBY MODE
STILL RESULT IN FIRE AND
AN INANIMATE OBJECT IF NOT USED PROPERLY
THE SCOPE OR THE LIGHT CABLE ON THE PATIENT
DRAPES
DEVICE IS IN STANDBY MODE
14
LWAYS CHECK TO ENSURE THAT THE UNIT HAS SWITCHED INTO
,
BEFORE ASSUMING ESST SAFETY PROTECTION
ESST
SAFETY PROTECTION
ESST
VEN WITH
,
NEVER PLACE THE TIP OF THE LIGHT CABLE OR
,
HE SCOPE TIP SCOPE LIGHT POST
,
OR OTHER FLAMMABLE MATERIAL
S
TANDBY MODE
. I
FEATURE N THIS CASE
,
AND RETURN THE UNIT FOR SERVICE
,
PROTECTION OR WHEN THE
,
AS BURNS OR FIRE MAY RESULT
,
/
OR BURNS TO THE PATIENT
.
,
THERE MAY BE A
,
DO NOT ASSUME
X8000
,
DRAPES OR
LIGHT CABLE ADAPTER
,
AND THEREFORE MAY
. D
O NOT PLACE
,
ON THE
,
EVEN WHEN THE
. I
F
.
IS IN
.
,
AND
, ,
USER OR