Worx MAKER X WX747 Manual Original página 17

OPERATION
1. Confirm the speed control button is set to
"Min". Grasp the tool by the grip. Press the On/Off
switch on the hub and that on the mini blower to start
the machine. (See Fig. D)
WARNING: Never use tools with defective On/
Off switch. In the case of all other types of
technical faults, please contact helpline or local
service center.
2. Adjust speed as needed. (See Fig. E)
The air speed is adjustable for a wide range of
applications. High speed can be used
to dust electronic devices, such as a computer
keyboard, laptop, copy machine, medical equipment,
camera, model vehicles, and blinds etc.
And low speed can be used for acrylic painting.
NOTE: After usage, press the on/off switch on the mini
blower and that on the hub to turn off the machine
and disconnect it from the hub. For sake of safety,
adjust the speed control button to "Min" position once
completing the operation.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0
The recommended ambient temperature range for the
charging system during charging is 0
C-45 C.
o o
C-40 C.
o o
MAINTENANCE
Remove the battery pack from the machine
before carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
EN
17