Before Use; Filling With Water; Sleep Mode - Mellerware Steamy! Manual De Instrucciones

Press the button on the back of the
–
ironing board to change the position
into vertical/horizontal (Fig.4).
Open the lock of the ironing board,
–
install the board along the telescopic
poles, and lock in place (Fig.5).
Position the lateral support
–
accessory (H) as indicated in Fig. 6.
If it is placed in another part of the
–
telescopic bars it may fall.
Hang the steam nozzle on the
–
collar hanger (D) or in the side
support accessory (H).
Instructions for use

BEFORE USE

Some parts of the appliance
–
have been lightly greased.
Consequently, the first time the
appliance is used a light smoke
may be detected. After a short
time, this smoke will disappear.
To eliminate the smell given off by
–
the appliance when used for the
first time, it is recommended to
have it on at full power for 2 hours
in a well-ventilated room.

FILLING WITH WATER

You must fill the water
–
compartment before turning on
the appliance.
Remove the appliance's water tank (I). –
Open the water inlet lid.
–
Fill the compartment with
–
cold water.
Close water inlet lid.
–
Put the deposit back into its housing,
–
ensuring that it is inserted properly.
USE
Extend the cable completely
–
before plugging it in.
Connect the appliance to
–
the mains.
Turn the appliance on, by using the
–
on/off button (j).
Wait for the pre-heating light (b) to
–
stop flashing and remain fixed, which
will indicate that the device has
reached the proper temperature.
Place the iron button in the
–
steam position (upwards). Wait
approximately 48 seconds and
steam will start to flow out.
The steam position down means
–
the iron works into normal mode
(without steam).

SLEEP MODE

In dry ironing or wet steaming state,
–
machine will enter to the sleep
mode after 15 minutes without any
electronic device operation.
The device resuming work will be
done within 3 minutes and it will take
around 25 seconds to pre-heat.
LACKING WATER INDICATOR
The machine will start its automatic
–
protection function and stop
working when the water tank is not
placed on the main body or if there
is a lack of water.
The water indicator light will start
–
flashing until the water tank filled is
placed in the main body.
EN