Inserting Hinges; Setting Up (Preparing For Work); Tools Used (Drill Bits) - BlueMax Mini Modular Plus Manual De Instrucciones

Setting up

Inserting hinges

Hinges are inserted using the 6-spindle interchangeable
drilling unit.
Carry out a function test before commencing production.
With frame hinged down, actuate safety switch to deactivate
motor while inserting hinge.
• Move panel against stop
1
• Press foot pedal or pushbutton.
• Hold-down clamps
.
place
• Hold-down clamps remain activated and continue to hold
panel in place.
• Fit a hinge into insertion die
• Using grip , move press-in frame
5
• Press foot switch (pushbutton) again
(One hand on press-in frame, one hand on pushbutton).
• The hinge is pressed into place.
en
NOTE
Connecting fittings are pressed in in the same way.
• Press pushbutton
• Hold-down clamps are raised and you can remove panel.
This concludes the work operation.
2. Preparing for work
WARNING
Warning - Hand injuries!
Before resetting the machine, disconnect mains plug
and detach compressed air supply!
First select the appropriate interchangeable drilling unit.
The machine comes in 4 versions.

Tools used (drill bits)

First install the drill bits required. This setting applies to all
interchangeable drilling units.
Insert required drill bit
the two screws using Allen key
7
When fitting, make sure drill bit chucking face
positioned. The screws must clamp the bit in position at this
face.
126
.
3
lock panel in place, and drilling takes
2
4.
under drilling unit
6
5.
into bayonet chuck and tighten
1 2
.
3
8
1
3
.
7
8
is correctly