General; Safety Check; Malfunctions On Start-Up; Starting Up For The First Time - BlueMax Mini Modular Plus Manual De Instrucciones

1. General

The instructions described here are to be understood as
minimum recommendations. Depending on operating
conditions, they may need to be broadened in order to
maintain the machine's working quality.
Servicing and maintenance work in specific disciplines
(pneumatics etc.) must only be carried out by skilled persons
trained in that particular discipline.
Observe the following safety advice!
WARNING
You could get crushed by moving parts if the machine is
not shut down.
The machine must be depressurised and disconnected
from the power supply before carrying out
maintenance and cleaning work!
NOTE
Improper repair will result in damage to the machine!
Improper dismantling and assembly may result in
property damage or consequential damage to the
machine.
Therefore, when carrying out any removal or dismantling
activity, always:
• mark parts that belong together
• mark or make a note of the position and point of
installation
• remove and store assemblies separately
After carrying out maintenance work, always:
• check all screw connections to make sure they are tight,
close and screw down all covers.
As with starting up, listen for unusual noises and check
to see if there is any heat buildup!

2. Safety check

The machine must only be put into operation by trained and
qualified personnel.
Satisfy yourself that:
• installation, set up and servicing work have been
completed in full and no persons are present in the danger
zone, let alone working on it,
• all safety guards / covers are in place,
• the compressed air supply is ready for operation, and
• the controls are readily accessible.
3. Malfunctions on start up
On start up, immediately switch OFF the power supply to the
machine if:
• unusual operating noises can be heard,
• the machine runs irregularly, oscillates or vibrates,
• auxiliary units malfunction,
• the motors consume too much power,
• there are electrical faults, and
• tools are overheating
DANGER
Danger from electric shock!
Working on live components in the improper manner
presents a danger to life!
Work on electrical equipment must only be carried out
by authorised electricians!
Establish the cause of any malfunction with the machine
shut down and made safe and have it rectified by a
qualified and skilled person trained to do so or eliminate the
malfunction yourself if you are in possession of the necessary
qualification.
Only switch the machine back on again once malfunctions /
faults have been properly and completely rectified!

4. Starting up for the first time

Before starting up the machine for the first time, observe the
following:
NOTE
The machine must only be put into operation for the first
time by a person instructed / authorised to do so by the
manufacturer / distributor or under the manufacturer's /
distributor's supervision.
• Check to make sure the machine has been installed in
accordance with the regulations specified.
• Make sure the machine stands firmly.
• Check to make sure that no foreign objects (tools,
construction material etc.) have been left in the area of the
machine from the assembly process.
• Check the hoses as well as the pneumatic system's hose
connections.
• Check the safety guards for proper working order.
• Make sure that moving components can move without
obstruction into the spaces they require and that the safety
distances are observed.
en
111