Worx MAKER X WX742 Manual Original página 13

air flow. Depress the trigger to start the air flow. Pull the trigger back to regulate paint
volume. Set maximum paint volume using the tail adjust screw. (See Fig. E)
NOTE: The speed is fixed, and can not be adjusted by the speed control button on the
hub.
2. Press the on/off switch on the hub to turn off after use.
WORKING HINTS
Before use, check the compressor and the spray gun to ensure they can work properly.
Please clean the feeding cup and spray gun instantly after use.
The nozzle may be clogged after long-term use. Please use the brush to clean.
Please carry out repairs or renovations under the guidance of after-sales staff.
MAINTENANCE
Remove the battery before carrying out any adjustment, servicing or mainte-
nance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the ventilation slots. This is normal
and will not damage your power tool. Store the accessories in a dry place.
Feeding cup maintenance
After use, pour the remaining panting in the feeding cup back into the original painting
bottle. Wipe clean the feeding cup with napkin. If dry painting left, wipe with thinner or
using a brush. If painting remains at the bottom, clean with a cotton bud. Finally, pour in
some thinner or water (depending upon the painting used) and turn on the air brush to
spray a few times to confirm that it is clean.
Spray gun maintenance
(1) Cleansing after short-term use:
Press the on/off switch on the hub to turn on. Pour some detergent or banana oil into
the feeding cup and block the nozzle with napkin. Wait for several minutes until the liquid
in the feeding cup is colorless.
(2) Cleansing after long-term use:
Painting may residue after long-term use. It is recommended to disassemble and clean
the air brush for better performance.
1. Follow the step in Cleansing after short-term use.
2. Pour into the feeding cup with detergent or banana oil (detergent is preferred as
banana oil is corrosive). Turn on the air brush to spray a few times until the painting
sprayed is colorless.
3. Disassemble the spray gun by loosening the nut. (See Fig. F1, F2) Carefully wipe clean
the needle, feeding cup and the nozzle. Finally, find a soft box to place the needle. Do
EN
13