11
MACHINE ACCESSORIES
The machine has various squeezing sets of Cups and Balls to use depending on the size of the fruit you
wish to squeeze.
Cup and ball in dark grey, for juicing fruit with a diameter of 63 to 75. If you need to squeeze
fruit with a diameter of 55 to 70, you need to fit the elastic accessory. (Fig. 13)
Optional. Cup and ball in light grey, for juicing fruit with a diameter of 75 to 90. If you need to
squeeze fruit with a diameter of 65 to 80, you need to fit the elastic accessory. (Fig. 14)
Regardless of the squeezing set use, the Blade will always be the same.
12
MACHINE MAINTENANCE
Exterior machine maintenance: simply requires daily cleaning.
Interior of the machine: After every 300,000 cycles, the inner machine guides and springs must be lubricated
and a full cleaning carried out.
Periodically lubricate the paddle shaft. (Fig. 15). Always use a lubricant approved for use with food products.
13
ADVICE FOR USE
Check that the oranges fit well in the cup you have chosen for squeezing, as if the cup is too small it will
score the peel and release the oil, giving the juice a bitter taste.
To get the maximum amount of juice, the cup should only be a little larger than the oranges you are
using.
We recommend turning off the machine when it is not going to be used. (Fig. 6)
14
IDENTIFYING DAMAGES
Damage
The display is not lit
The display shows
message Error
The display shows
message Error and a
flashing Icon.
18
ATTENTION!: Never mix components of different sets.
Cause and/or solution
No power supply.
Fuse burnt out. (Fig. 11)
Power cable not properly connected.
Switch power on. (Fig. 6)
Damp in circuit board. Supply dry heat to the board.
Cover badly fitted. (Fig. 16)
Filter tray out of place. (Fig.17)
Upper protective device badly fitted. (Fig. 18)
Bin badly fitted. (Fig. 19)
Motor overheating.
See section 9.
Check to see if the oranges being squeezed are frozen.
Check to see if peel has built up in the juicer tray.
Check to see if the ball has not been properly screwed in.
Check to see if peel has become stuck inside the cup.
Check that you haven't fitted different sizes of cup and ball.
The skin of the fruit may be too thick. Remove the washer from underneath
the ball.
To unblock the machine, use the 3mm Allen key to the right of the lower
grille of the machine. Insert it into the hole on the right-hand side and, with
the machine unplugged, turn it in a clockwise direction until you can raise
the cup and release the blockage. IMPORTANT: before plugging in the
machine, make sure you have removed the key from its fitting.